7,938 reputation
1429
bio website paleogeeks.com
location San Diego, CA
age 32
visits member for 4 years, 5 months
seen Jan 22 at 14:47

Band Geek / Sportbike Racer / Crossfitter / IT pays the bills...


Dec
24
reviewed Approve error while trying to empty a directory
Dec
2
comment iSCSI Datastores not found after Power Failure
Yes Ben, exactly. Set the storage host to boot immediately, and the virtual hosts to wait say... 90 seconds. Also keep in mind though, that if this was a hard power-off, a disk-check might be forced.
Dec
2
comment iSCSI Datastores not found after Power Failure
What kind of server hardware? Most allow you to set a delay for auto-power on after failure.
Nov
20
comment Syslog-ng how to get domain names instead of IP address
Do reverse DNS records exist for the IP addresses you are receiving syslog data from?
Nov
18
comment Connect Server to multiple Networks
FYI, you can have multiple gateways set, the interface metric then decides which one is used.
Nov
13
comment antivirus for sharepoint
I suppose since it doesn't have an accepted answer it's still available, but this is a year old question.
Oct
29
answered iSCSI: LUNs per target?
Oct
26
comment Connecting to a remote server through a VPN when the local network subnet address conflicts with a remote network
You can try setting a static route for the /32 address of the host you're trying to reach and use the VPN peer as your gateway and see what happens.
Oct
18
comment VMWare Guest NIC Teaming
You don't need LACP to create a port-channel, it just ensures both sides of the link work properly.
Oct
17
comment BOOTP on Juniper 4200 stack works one one subnet, not another
Are you certain your vlan sub-interfaces match properly? It's not ALWAYS certain that vlan.11 refers to tag 11, and so forth.
Oct
13
answered ESXi network setup for isolated internal virtual machines
Oct
9
comment How to add multiple IPv4 Subnets to a VLAN using Allied Telesyn at9924 Switch?
Alliedware seems to protect their core manual. What you're after is called a "secondary" ip address in Cisco terms. They might allow you to create subinterfaces ie... int vlan15.2 wish I could give you more but without documentation I can't.
Oct
9
comment How to add multiple IPv4 Subnets to a VLAN using Allied Telesyn at9924 Switch?
Yes, but it won't route it.
Oct
3
answered If my DNS is a VM with HA do I need a secondary?
Sep
26
comment PS6000 showing packet errors but no errors appear on the switch
A diagram please, kinda hard to tell whats connected to what.
Sep
20
comment Blocking STP Traffic
What kind of switch is your system connected to? A managed switch has the capability to put ports in an STP mode that quiets this down a bit.
Sep
19
answered is it possible to use ms loop back adapter to setup local vlan
Sep
7
answered Is it possible to detect the original IP performing a port scanning to a public service through a VPN server?
Aug
21
comment Fibre Channel Link Aggregation
Our Cisco MDS and UCS fabric interconnects form port-channels between each other?
Aug
15
comment Application fails when only one of two Active Directory server is off
Are both servers setup as global catalog servers?