7,846 reputation
1426
bio website paleogeeks.com
location San Diego, CA
age 32
visits member for 4 years
seen 5 hours ago

Band Geek / Sportbike Racer / Crossfitter / IT pays the bills...


Jun
20
comment Is it worth it to do revision control/puppet/etc. on a single-server-setup?
Sounds like a lot of effort with very little return. Solid backups and config file version control are probably all you need.
Jun
18
comment Virtualized MS-DOS computers cant communicate over IPX
They are configured to the same port group on the same vSwitch, right?
Jun
14
awarded  Notable Question
Jun
13
comment Site-To-Site VPN Failover
What types of Cisco devices? Routers? Firewalls?
Jun
13
comment Small network: any disadvantages to downgrading to local accounts with mapped drives only?
I would like point out that whether or not you use Active Directory or not, that if the "Server" is still serving files, your legally required to maintain the same licensing. You could do it cheaper with a cheap NAS however.
Jun
9
answered How Do I tie 2 ports of I have a dell 5448 togather for a teamed pair of broadcomm nic's
Jun
6
answered ssh command not working on juniper router
Jun
2
comment If I `sudo reboot` my Ubuntu 12.04.2 server with Postgres running, can I lose data?
Assuming it was properly installed :)
May
11
comment Network packet loss and major connection issues
NAT does not incur latency, but it can make forwarding complicated. This sounds like a link stability issue.
May
9
comment Cisco ASA ipsec vs Anyconnect client issue
When you use Anyconnect, are you referencing the same group as when you use the IPSec connection?
May
8
comment Cisco ASA ipsec vs Anyconnect client issue
Are they using the same or different IP pools? How about you post some configuration snippets?
May
2
comment Monitoring bandwidth on multiple hosts with no control of a router
Take a look at NTOP
May
2
answered Cheapest Way To Stack 48 Port Switch With My Dell 6248?
Apr
29
comment monitor traffic using port mirroring and wireshark
For one device? As a diagnostic tool? Install free version of scrutininzer, done.
Apr
25
comment Who picked 127.0.0.1 to be localhost and why? What meaning does it have?
Seek and ye shall find the RFC
Apr
25
comment Using a CIDR range as a Routed Subnet?
It's automatic on Sonicwall, unless you specifically disable it, I believe.
Apr
25
answered Using a CIDR range as a Routed Subnet?
Apr
25
comment Static into OSPF Redistribution
The only thing that comes to mind is setting up a VRF and having it peer to itself in that VRF so that you have this cute little island onboard to show you what's being exported into your routing topologies
Apr
25
comment Static into OSPF Redistribution
How would the originator of the route also be a receiver? This request doesn't make sense at all?
Apr
25
answered SRX220: Cant ping between hosts in directly attached networks through SRX