163 reputation
311
bio website
location New York, United States
age 35
visits member for 3 years
seen Aug 15 at 12:08

merge keep


Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
Please see Update3 in my question. Appreciate your time and help.
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
Please see Update3 in my question. Appreciate your time and help.
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
I have root on zmirror, so no need for network. Any way to debug what exactly scripts are doing, even deeper than rc_debug="YES"?
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
Thanks - corrected.
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
Didn't solve, stuck at same spot. with igb0 showing it got link UP 4 seconds after bridge0.
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
@chris-s What I see when enabled debug in rc.conf, is that routing script starts before igb0 shows that it has link. and igb0 gets link 4 seconds after bridge0 and and three seconds sfxge0/1 are up.
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
I've added rest of my rc.conf to the end of my question.
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
Actually... here is mine /etc/rc.local: ifconfig sfxge0 up ifconfig sfxge1 up ifconfig bridge0 create ifconfig bridge0 addm sfxge0 addm sfxge1 up ifconfig bridge0 inet 172.18.0.1/24 When I had if sfxge0 & sfxge1 after bridge creation - bridge was created, but did not work.
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
system boots properly when bridge configured from rc.local and I've used commands mentioned in the bost above (three ifconfigs).
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
I set network_interfaces and issue still there. should I add bridge0 to the end of it? Setting sfxge1 with ip address - allowed system to boot properly.
Mar
22
comment FreeBSD 9.1; bridge0 and default gateway issue
I've tried that - same issue. Even tried to use defaultroute_carrier_delay=15 to allow time for ibg0 interface to come up, but didn't solve that issue.
Nov
14
comment Compiling realtime kernel from RHEL 6 MRG sources on CentOS 6
It didn't compile properly to produce proper .rmp files. I didn't try if recent version compile, as I'm using precompiled RT kernels from Scientific Linux
Mar
27
comment ptp time synchronization on centos6/rhel
@luc no, this setup was for slave. difference is in arguments you pass via PTPDARGS in /etc/sysconfig/ptpd2
Jan
10
comment haproxy acl - accept only from specific IPs
@Khaled there is no NATing between hosts. Requests are coming from those IPs.
Nov
16
comment Compiling realtime kernel from RHEL 6 MRG sources on CentOS 6
of course I tried --with firmware - it does not help. LSI 9265-8i
Nov
16
comment Compiling realtime kernel from RHEL 6 MRG sources on CentOS 6
yes i need to add drivers for my raid controller. I've built it using command suggested by you - still didn't get kernel-rt-firmware package built...
Nov
9
comment ptp time synchronization on centos6/rhel
@DavidSchwartz: I specifically was told to use PTP. NTP is not accurate enough for that task.