1

I am trying to attach a ebs volume to an ec2 instance, with this :

$response = $ec2->attach_volume($volume_id, $disp['instanceId'], '/dev/sdf');

It goes to "attaching" state, then to "attached" state, after few seconds, it goes back to "attaching" state.

Why ?

1 Answer 1

0

Possible just a bad EBS controller, but I have not used the SDKs for attaching volumes. May be better to ask this on the Amazon Dev Forums instead, their techs can take a look at it.

1
  • restarting the instance sorted it out, but I wasn't really happy about it..
    – Shrinath
    Dec 22, 2010 at 10:09

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .