0

Server has two 10GBASE-CX4 ports. client has 10GBASE CX4 HBA.

can theybe directly connected with a CX4 cable without the need for a switch? like SAS Infiband connectors?

2
  • 1
    You keep asking the same questions over and over again.
    – ewwhite
    Dec 30, 2010 at 22:25
  • i dont intend to ask same questions. since i bought the CX4 hardware and looking for a switch someone told be direct access using cable is possible for 1-1 and can save the cost of 10G switch
    – JMS77
    Dec 31, 2010 at 3:00

2 Answers 2

2

Yes, it works perfectly fine without a switch. Give each system an IP on the same subnet.

I've run this setup with dual-port Intel CX4 10GbE cards between a VMware host server and a Sun x4540 storage unit.

2

Check if your NICs support auto-MDIX. I think it is a required part of the 10GE standard but I couldn't verify that.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .