I work with Fortigate gear a lot and in the CLI it's possible to navigate to a node (say config system global
then type in show
and it will show me the configuration from that block.
In IOS I can't figure out how to do this, I know I can exit conf term
mode and use show run
but the configs can be very long.
Is it possible while in say:
router>en
router#conf t
router(config)#interf f0/1
To type a command that will show me only the config section like this:
interface FastEthernet0/1
no ip address
speed auto
full-duplex
pppoe enable group global
pppoe-client dial-pool-number 1
Thanks for any advice!