3

My Dell PowerEdge R200 just stopped working over the weekend and won't boot.

The power indicator is flashing green, indicating standby mode and doesn't seem to be able to get out of it.

The "information" indicator (the little i) is flashing blue.

The system seems to be stuck in standby mode. On removing the cover, the fans are working.

Any suggestions?

4
  • 2
    If you still have support, call dell support.
    – Reaces
    Jan 2, 2015 at 10:19
  • 1
    We haven't got support anymore i have looked for information and that's why i'm aking on the forum.
    – Andrew
    Jan 2, 2015 at 10:49
  • 2
    The R200 should have a POST indicator that highlights any issues (if there is no beeptone). You can find these indicators in the owners manual
    – Reaces
    Jan 2, 2015 at 10:59
  • Same here, unfortunately POST codes are useless because the server reboots before turning any led (letter) on.
    – S19N
    Apr 27, 2016 at 9:32

2 Answers 2

7
+25

Well, right up front, let me tell that the outlook is not good. 10:1 (at least) that your motherboard is bad and needs to be replaced.

The standard troubleshooting approach to this problem is to remove components from the motherboard until you find the one that causes the boot failure.

For these symptoms, I would start by removing all the components - PCI cards, RAM, and even the CPU. The only things you should leave plugged into the motherboard is the power cable from the PSU and the onboard speaker (if that's not an integrated component). You can also leave a fan or two plugged in if you want to verify and visually determine when the PSU is supplying power. With no CPU and no RAM in the board, when you power it on, a healthy motherboard will beep the corresponding beep code, and should also light up the corresponding LED error code to indicate those failure conditions. If (when) it doesn't, that tells you that the motherboard has a hardware fault and needs replaced.

(If you do get the expected beep and LED codes, of course, that indicates that the motherboard is functional and one of the components is faulting and preventing the computer from booting. Add components back in until you add one in that stops the server from booting, and that's your faulty component.)

I've seen this roughly a few dozen times over my career, and I can only recall once when it wasn't the motherboard (the PSU had faulted and was only providing a few watts worth of power - enough for a fan, but not enough for anything else).

4

I would consult the hardware manual here located here ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_poweredge/poweredge-r200_Owner%27s%20Manual_en-us.pdf

Page 29 has the diagnostic indicator codes.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .