I am using Juniper J-series routers to emulate a small telco and VPN customer.I need to use OSPF so that the routing information can be propagated to all P and PE nodes (basically all core and edge routers).Note that I don't want the routing information to be propogated to the customer facing routers (the green ones.)
TAU-PE1:
set protocols ospf area 0.0.0.0 interface ge-0/0/0
set protocols ospf area 0.0.0.0 interface ge-0/0/1
set protocols ospf area 0.0.0.0 interface lo0.0 passive (loopback)
set protocols ospf area 0.0.0.0 interface ge-0/0/2.0 passive (customer facing)
HAM-PE1:
set protocols ospf area 0.0.0.0 interface ge-0/0/0
set protocols ospf area 0.0.0.0 interface lo0.0 passive (loopback)
set protocols ospf area 0.0.0.0 interface ge-0/0/2.0 passive (customer facing)
TAU-P1:
set protocols ospf area 0.0.0.0 interface ge-0/0/0
set protocols ospf area 0.0.0.0 interface ge-0/0/1
set protocols ospf area 0.0.0.0 interface ge-0/0/2
set protocols ospf area 0.0.0.0 interface lo0.0 passive (loopback)
ACK-P1:
set protocols ospf area 0.0.0.0 interface ge-0/0/0
set protocols ospf area 0.0.0.0 interface ge-0/0/2
set protocols ospf area 0.0.0.0 interface ge-0/0/3
set protocols ospf area 0.0.0.0 interface lo0.0 passive (loopback)
HAM-P1:
set protocols ospf area 0.0.0.0 interface ge-0/0/0
set protocols ospf area 0.0.0.0 interface ge-0/0/1
set protocols ospf area 0.0.0.0 interface ge-0/0/3
set protocols ospf area 0.0.0.0 interface lo0.0 passive (loopback)
Now I want to enable the following things on all PE and P nodes.
1) MPLS 2) RSVP 3) OSPF-TE extension
As an example on TAU-P1
set protocols mpls interface ge-0/0/0
set protocols mpls interface ge-0/0/1
set protocols mpls interface ge-0/0/2
set protocols rsvp interface ge-0/0/0
set protocols rsvp interface ge-0/0/1
set protocols rsvp interface ge-0/0/2
set protocols ospf traffic-engineering interface ge-0/0/0
set protocols ospf traffic-engineering interface ge-0/0/1
set protocols ospf traffic-engineering interface ge-0/0/2
Are the below steps sufficient to achieve the above? Any help is appreciated.