1

I tried to set (change) the mode of my port, and I read the book and followed it step by step. But I still get a lot of error.

There were what I input.

(Routing) (Interface 0/3)#switchport mode general

                                                              ^

(Routing) (Interface 0/6)#switchport mode access

                                       ^

(Routing) (Interface 0/6)#switchport mode trunk

                                       ^

All of the problems are Invalid input detected at '^' marker.

I search a lot, and everyone always says "switchport mode access/trunk/general", but I could not input it.

Why?

3
  • 1
    What model device is this?
    – Ron Trunk
    Sep 12, 2018 at 2:43
  • @RonTrunk Croton+
    – Steve
    Sep 12, 2018 at 3:37
  • use question mark or tab to see the options after switchport mode
    – errorfetch
    Sep 12, 2018 at 7:09

0

You must log in to answer this question.

Browse other questions tagged .