0

Going by the PDF here: http://www.staroceans.org/e-book/S2B%20IPMI%20Commands.pdf, which is for the SBR firmware found on the D51B-1u quanta Quantagrid 1u server, it seems you should be able to adust the fans using these commands:

    61. Fan Command (1U)
Type Command Format Description
In Band
ipmitool raw 0x30 0x39 0x01 0x10x0 0x3f
Set BP fan 0 to 63
duties
(=0x3fheximal;
maximum duty is 63)
ipmitool raw 0x30 0x39 0x01 0x10x1 0x3f Set BP fan 1 to 63
duties
ipmitool raw 0x30 0x39 0x01 0x10x2 0x3f Set BP fan 2 to 63
duties
ipmitool raw 0x30 0x39 0x01 0x10x3 0x3f Set BP fan 3 to 63
duties
ipmitool raw 0x30 0x39 0x01 0x10x4 0x3f Set BP fan 4 to 63
duties
ipmitool raw 0x30 0x39 0x01 0x10x5 0x3f Set BP fan 5 to 63
duties

Although this pdf says its for the D51B 1/2u chassis, when running these commands, you get the following error:

 ipmitool raw 0x30 0x39 0x01 0x10x4 0x3f
Given data "0x10x4" is invalid.

Is there a way to somehow get a list of the valid hex values for ipmitool raw to see if maybe it's as simple as changing 0x10x4 to something else?

I tried running the commands for the 2U from that doc, but doesn't seem to do anything.

Thanks!

0

It looks like there should be a space in the command. Check the 2U command just below this one in the guide.

Try this one -

ipmitool raw 0x30 0x39 0x01 0x1 0x1 0x3f
1
  • omg thank you. the 0x4 was wrong in the manual i guess.. it now works: Fan_SYS0_0 | 6200 RPM | ok Fan_SYS0_1 | 5200 RPM | ok Fan_SYS1_0 | 6300 RPM | ok Fan_SYS1_1 | 5200 RPM | ok Fan_SYS2_0 | 6400 RPM | ok Fan_SYS2_1 | 5300 RPM | ok Fan_SYS3_0 | 13100 RPM | ok Fan_SYS3_1 | 10900 RPM | ok Fan_SYS4_0 | 12800 RPM | ok Fan_SYS4_1 | 10800 RPM | ok Fan_SYS5_0 | 12800 RPM | ok Fan_SYS5_1 | 10800 RPM | ok – Evan R. May 15 '20 at 3:08

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.