Linux/iptables: best way to clear all rules, leaving anything open

Question

Currently have this snippet:

iptables -F // flush all chains
iptables -t nat -F
iptables -t mangle -F
iptables -X // delete all chains

Is there a possibility that some impervious rule will stay alive after running this?

The idea is to have a completely clean iptables config, that can be easily replaced by new ruleset (nevermind routes/ifconfig's parameters).

Answer 1

To answer your question succinctly, no: there would not be any "leftover" rules after flushing every table. In the interest of being thorough however, you may want to set the policy for the built-in INPUT and FORWARD chains to ACCEPT, as well:

iptables -P INPUT ACCEPT
iptables -P FORWARD ACCEPT
iptables -P OUTPUT ACCEPT
iptables -t nat -F
iptables -t mangle -F
iptables -F
iptables -X

Clear ip6tables rules:

ip6tables -P INPUT ACCEPT
ip6tables -P FORWARD ACCEPT
ip6tables -P OUTPUT ACCEPT
ip6tables -t nat -F
ip6tables -t mangle -F
ip6tables -F
ip6tables -X

...and that should do it. iptables -nvL should produce this (or very similar) output:

Chain INPUT (policy ACCEPT 0 packets, 0 bytes)
 pkts bytes target     prot opt in     out     source               destination

Chain FORWARD (policy ACCEPT 0 packets, 0 bytes)
 pkts bytes target     prot opt in     out     source               destination

Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes)
 pkts bytes target     prot opt in     out     source               destination

Answer 2

This will correctly totally reset your iptables system to a very basic state:

iptables-save | awk '/^[*]/ { print $1 } 
                     /^:[A-Z]+ [^-]/ { print $1 " ACCEPT" ; }
                     /COMMIT/ { print $0; }' | iptables-restore

All policies will be reset to ACCEPT as well as flushing every table in current use. All chains other than the built in chains will no longer exist.

Answer 3

Whenever I need the firewall disabled is something like this:

• iptables-save > iptables.bak
• service iptables stop (i'm on fedora)

Answer 4

One can do this in 1 or 2 commands:

 $ sudo iptables-save > iptables.bak
 $ sudo iptables -F

Result:

$ sudo iptables -nvL
Chain INPUT (policy ACCEPT 3138 packets, 5567K bytes)
pkts bytes target     prot opt in     out     source               destination         

Chain FORWARD (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target     prot opt in     out     source               destination         

Chain OUTPUT (policy ACCEPT 3602 packets, 6547K bytes)
pkts bytes target     prot opt in     out     source               destination