I have a dell switch 6200.

I am trying to add a new VLAN to the current VLANs. I currently have a VLAN that is 192.168.01 The default Gateway is

I created a VLAN but I cannot get access to the internet. I don't understand why is the default gateway for the other VLAN.

How would add a Default Gateway to to allow me to get internet access?

  • What device currently owns, your Dell switch, or your firewall/router? Commented Nov 14, 2012 at 2:42

2 Answers 2


You will need a gateway on the vlan too. Without it, there is no way a device can connect to another vlan.

Depending on what you use as a router, it might be possible to configure the port towards it as a trunk, and configure your router to be on two vlans at the same time.


Replace VLAN with network and read this: How does IPv4 Subnetting Work?


You have a network 192.168.0/24. All traffic on for that network gets sent to it. All traffic with a different destination get send via the gateway, which is on the 192.168.0/24 network and thus is directly reachable.

Now you add a second network. 192.168.5/24. All traffic for that specific network can be sent to it. All traffic with a different destination needs a gateway which is directly reachable from 192.168.5/24. That does not include

How would adding a default gateway to to allow me to get internet access?

It would not. You will need a NIC in the local network (192.168.5/24) which can forward packets to and from other networks. Assuming that everywhere you wrote VLAN you meant 'network' or 'LAN' then you can do this by adding a second IP and appropriate routing tables to the host which currently serves as the gateway for the 192.168.0/24 network.

However as your question currently stands that requires some guessing. You will either need to clarify it or learn how subnetting and routing works.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .