I am working on reselling a tripp lite PDU for my company, and I need to know how to reset it to default factory settings. In other threads it says to push the reset pin, however there is no pinhole on the unit to push. Please if anybody has any ideas I am working with a Tripp Lite PDUMV30HVNET. Thanks!
The reset pin on that unit is near the panel with the Ethernet and Serial interfaces. See the manual.
If you previously had connectivity to the unit, you can also do this from the web and serial interfaces. But in the end, it's a PDU. Is there any company-specific information contained within?
Assuming this is your unit, there looks like a little reset button above the Config port. Barring that working (try holding it in with a paperclip for 20 seconds), you should be able to connect a console cable into that Config port, and connect using a terminal.
Use the console cable. Plug into a machine and launch a terminal program. Reboot the PDU. When you see the device post it will display the config and allow you to press a key within 5 seconds to change the config.
The default Root Password is TrippLite. From there you will be prompted with questions. One of them asks if you want to Restore Factory Defaults. Say Yes.
Source here. Good luck!