5

I have a 3ware 9650-SE controller with 2 drives in RAID-1 configuration. The drive on "port 1" has an error but the drive cages aren't labeled. I tried using the cli to "identify" the drive but tw_cli just spits out "N/A". I thought this might blink the drive activity LED but no:

# tw_cli /c7/p1 set identify=on
Setting port Identify on /c7/p1 to [on] ... N/A

How can I blink the drive activity of the individual port to find out which drive in the array is the one which is bad?

6

Found a way to do it using the "show all" command on a shell loop:

# while [ 1 ] ;do  tw_cli  /c7/p0 show all; done

This creates sufficient access to the individual drive (p0) to blink the light on the drive bay.

  • Same problems here… Thanks for the neat workaround. – Michael Simons Dec 2 '15 at 9:08
3

Now, if you happened to inherit a Windows Server with a 3ware RAID card, you can do something similar with powershell:

PS C:\Users\Administrator> while ( 1 ) { tw_cli /c7/p0 show all }

And, when you have replaced the drive and want to see the rebuild status, you can use the same trick to get something similar to the watch command in Linux:

PS C:\Users\Administrator> while ( 1 ) { clear ; tw_cli info c7 ; sleep 5 }

HTH.

Your Answer

By clicking "Post Your Answer", you acknowledge that you have read our updated terms of service, privacy policy and cookie policy, and that your continued use of the website is subject to these policies.

Not the answer you're looking for? Browse other questions tagged or ask your own question.