1

I use a raw block (whole disk like /dev/sdb1) as KVM virtual disk. Anyone know how to mount that partition from the host?

My testdisk output is like this:

~# testdisk /list /dev/sdb1
TestDisk 7.0, Data Recovery Utility, April 2015
Christophe GRENIER <grenier@cgsecurity.org>
http://www.cgsecurity.org
Please wait...
Disk /dev/sdb1 - 500 GB / 465 GiB - CHS 60801 255 63
Sector size:512
Model: WDC WD5000HHTZ-04N21V1, S/N:WD-WXJ1EA3JNLK3, FW:04.06A01

Disk /dev/sdb1 - 500 GB / 465 GiB - CHS 60801 255 63
 Partition          Start        End    Size in sectors
 1 P HPFS - NTFS              0  32 33 60800 237 45  976764928
 NTFS, blocksize=4096

I tried to mount like - mount -t nfs /dev/sdb1 /mnt/mydrive

does not work.

Any suggestions would be appreciated.

0

You have a nested partition table. You're going to have to make a loop device at a the needed offset of sdb1.

This output is giving values in CHS. You should display this using sectors instead, using fdisk or parted. However, it looks like this is a zero bit offset. I'll assume this is the case unless you verify otherwise

losetup /dev/loop0 /dev/sdb1

This will create the loop device you need, binding /dev/sdb1 to the first loop device /dev/loop0. Once you've done this, you can create partitions out of that. You can do this using partprobe:

# partprobe /dev/loop0

This will spawn devices like /dev/loop0p1. At this point, you should be able to mount this nested partition directly:

# mount /dev/loop0p1 /mnt/mydrive

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.