1

Giving this topology as an example, Network topology

I am working on an exercise for university and up so far I have implemented inter vlan routing, spanning tree, link aggregation and DHCP. For the last part I need to implement OSPF and my question is:

Once setting up the OSPF in each router, do I need to advertise the network that corresponds to the IP's given to each end device or should I only advertise the networks corresponding to each of the router's links?

At the moment I have configured OSPF in all 4 routers with the network corresponding to each of the links and can ping between all routers but not from end device to ELSEWHERE/EDGE or Campus.

Hope I was clear enough about my question. Thank you in advance!

5
  • redistribute connected Mar 3, 2017 at 12:29
  • show ip route ospf Mar 3, 2017 at 12:30
  • and yes, if you have l3 interfaces on your switches, set therm up the same Mar 3, 2017 at 12:31
  • 1
    @JacobEvans I have just done it and worked perfectly. Thanks for the answer!
    – JGuerra
    Mar 3, 2017 at 12:52
  • cool, now do the same with ipv6:) Mar 3, 2017 at 12:56

1 Answer 1

1

configure ospf on any device routing L3 traffic (switches included)

then the easiest thing is to just redistribute connected

use show ip route ospf to confirm.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .