1

So the systems I am using are MX960 MPC7e.

When I use the 1meter 100G DAC I have zero errors + zero packet loss.

When I use the 3meter 100G DAC cables I have packet loss & framing errors. I tried 3 DAC cables on 2 different sets of routers…all MX960 MPC7e.

These are 3rd party DAC cables, all from the same place, but what I do not understand is why the 1M cables work and the 3M are giving me errors. The only difference between the cables that I have noticed is that the 3M are 28AWG and the 1M are 30AWG.

Any ideas as to what the issue is? I would think it was just a bad cable, but all 3 of them seems a little strange.

2
  • Cheap substandard cables are common. It would be far stranger to me if you tried 3 from all different places and they all had the same behavior but at least that would indicate it might not be the cables.
    – user143703
    Aug 24, 2017 at 23:14
  • Been using this vendor for years, going through hundreds of the same DAC without issues, until these three Juniper ones... That is why I find it strange.
    – KrisGT
    Aug 25, 2017 at 0:47

1 Answer 1

1

It seems this issue was not only because of the length and gauge of the cable but also the design of the PCBs in the transceiver end. Switching to a 26AWG cable improved the performance of the cable enough to get rid of these errors.

Different gauge cables can still be used but would need to acquire them from a different source that has improved PCB.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.