0

I have a APC rack PDU here. It should be AP7953, although that doesn't show in the telnet interface: 

About System

Model Number      :
Serial Number     :
NMC Serial Number :
Manufacture Date  : ~
Hardware Revision :
MAC Address       : 72 61 73 65 00 00
Flash Type        : AMD A29DL322DB

This is a unit with 24 outlets, but the telnet interface only shows 8. Also, switching on all outlets ("Master control") doesn't actually switch on anything.

Both the OS and the RPDU application on the PDU have been upgraded to 3.9.2.

What can I do to regain control of the PDU outlets?

Improve this question

1 Answer 1

Reset to default
2

Open a case with APC. On different equipment I would say that the device has lost connection to its backplane.

Improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .