2

So an issue I am running into is that I have a Storage Pool using S2D created, it shows less than 2 GB used up... but when I go to run the virtual disk wizard, it has Free Space: 0.00 GB for both performance and capacity tier. Due to this, Any value I specify says it goes beyond the available resources.

Do they need to be formatted? Do I need to run some other powershell command to make them do their thing?

Virtual disk wizard Free space 0.00 GB

2
  • 1
    Did you configure S2D properly? Do you have the same (and enough!) amount of disks added to S2D pool on each node? How many nodes / disks / SSDs do you have? May 1, 2019 at 11:47
  • 4 disks, 1 per node, all VHDDs. I ended up removing them all and re-adding them again (didn't change the setup) and creating the pool on a different VM using powershell. Command was (paraphrased) New-Volume -FriendlyName "ClustervDisk0" -FileSystem CSVFS_ReFS -StoragePoolFriendlyName Cluster* -usemaximumsize -ResiliencySettingName Parity -PhysicalDiskRedundancy 2
    – Manchuwook
    May 10, 2019 at 0:06

1 Answer 1

0

I ended up using powershell on a different machine in the cluster after removing and re-adding the VHDs:

New-Volume -FriendlyName "ClustervDisk0" -FileSystem CSVFS_ReFS -StoragePoolFriendlyName Cluster* -usemaximumsize -ResiliencySettingName Parity -PhysicalDiskRedundancy 2

Unfortunately, I don't know how much this will help others because it might be very specific to my installation. The command above was for 2 500GB VHDDs and 2 250GB VHDDs, with 1 drive per cluster node.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .