Server Fault is a question and answer site for system and network administrators. It only takes a minute to sign up.
Sign up to join this community
We have a working connection to our ASA from our ISP, and we have it configured with an address range of:
Public LAN: xxx.xxx.xxx.xxx/28
Subnet Mask: 255.255.255.240
on the outside interface. We asked our ISP for another block of IPs, and they gave us another range of IPs:
Public LAN: yyy.yyy.yyy.yyy/28
Subnet Mask: 255.255.255.240
How can I add this new set of IPs to the outside interface on the Cisco ASA 5505?
You just need to add them with the secondary switch i.e. from inside of the interface config
(config-if)#ip address yyyy.yyyy.yyyy.yyyy 255.255.255.240 secondary
secondary parameter is not supported on an ASA 5505. You'd have to proxy arp the second IP and route accordingly from the gateway.
– gravyface
Jan 7 '11 at 22:17
We had to add a route on our gateway device, a router that was in front of the ASA. This was preventing the traffic from getting to the ASA. We routed all traffic to one of the working xxx.xxx.xxx.xxx addresses.
